I have a problem. I flashed my Anet to version 1.18 with "all" the BL-Touch changes.
On start up the BL retract 2 times en stays the pin is in the high position
If I do G28 Z the machine never stops. I have to switch if off.
But when I place the BL above the bed and I do the G28 Z-command I have to do M280 PO S10 and it makes a complete Z-leveling. After that I have to do M280 PO S90.
What is wrong with my configuration.
With regards, Frans Bos
On start up the BL retract 2 times en stays the pin is in the high position
If I do G28 Z the machine never stops. I have to switch if off.
But when I place the BL above the bed and I do the G28 Z-command I have to do M280 PO S10 and it makes a complete Z-leveling. After that I have to do M280 PO S90.
What is wrong with my configuration.
With regards, Frans Bos
