Hi
For you is this a verry good solution , I see.
I have no trouble with the first layer on my bed , I use Mesh leveling ( 9 points) and is always , after a fiew testprints OK.
My problem is the distance from the bed when the printhead is at Home position X=0 Y=0 (rest position afther home command) , I wand this Z at least 5mm high.
For you is this a verry good solution , I see.
I have no trouble with the first layer on my bed , I use Mesh leveling ( 9 points) and is always , after a fiew testprints OK.
My problem is the distance from the bed when the printhead is at Home position X=0 Y=0 (rest position afther home command) , I wand this Z at least 5mm high.