Ok Guys,
Found the culprit. It was this line
Doing my first test now and the bed went correctly to 0.33mm, which was my first layer height.
Thank you all for the help you provided.
Regards,
Marcus
Found the culprit. It was this line
#define Z_PROBE_LOW_POINT -10 // Farthest distance below the trigger-point to go before stopping.When the errors were occurring I had the value set to zero (0). I changed to -10mm and now I can calibrate all points.
Doing my first test now and the bed went correctly to 0.33mm, which was my first layer height.
Thank you all for the help you provided.
Regards,
Marcus