Hey Gentlemen,
Not sure if good news but at least something different.
With #define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below [the nozzle], sent a G29 command and waited for the result (only one point to speed up the process). Got 18.78mm. Added 3.5mm to this and sent M851 Z-22.28, M500 and then a M501 to make sure it was saved.
Moved the extruder to (100,100) and Z to 10. As it looked ok, started sending decreasing Z and got the nozzle exactly touching the bed.
Homed Z again and sent another G29. After probing, got the value -3.495mm. Sent the nozzle to (100,100) and lowered Z to 0. Now I get around 15mm from the nozzle to the bed.
Guess we are getting close but need some help in here.
Regards
Marcus
Not sure if good news but at least something different.
With #define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below [the nozzle], sent a G29 command and waited for the result (only one point to speed up the process). Got 18.78mm. Added 3.5mm to this and sent M851 Z-22.28, M500 and then a M501 to make sure it was saved.
Moved the extruder to (100,100) and Z to 10. As it looked ok, started sending decreasing Z and got the nozzle exactly touching the bed.
Homed Z again and sent another G29. After probing, got the value -3.495mm. Sent the nozzle to (100,100) and lowered Z to 0. Now I get around 15mm from the nozzle to the bed.
Guess we are getting close but need some help in here.
Regards
Marcus