Ah I see... non standard connectors for extruders where everything is grouped together... didn't notice this originally.
yes you will have to solder in a new header
after quite a bit of searching I found this circuit diagram [github.com]
and new firmware [github.com]
with is own boards file [github.com]
but this doesn't tell you directly what the thermistor pins are
So it one of the above 4
yes you will have to solder in a new header
after quite a bit of searching I found this circuit diagram [github.com]
and new firmware [github.com]
with is own boards file [github.com]
but this doesn't tell you directly what the thermistor pins are
name, phiscal pin, arduino pin t2 86 analog 11 t bed 87 analog 10 t1 88 analog 9 t0 89 analog 8
So it one of the above 4