[attachment 107609 RADDS_Pin_Size-1.png]
Ok...so where do i need to change the pins...in marlin 2.0, under pins_RADDS.h?
I will use the available pins from max endstop,or from lcd connector that is on radds...because i don't planing to use lcd...or if i will use lcd...i have the aux1 pins available as well..that aux1 pins on radds is for adding the extra extruders with the expansion board v2 or v3
so my question is that i have to activate serial in marlin...or only need to assign the tx and rx pin for each axis where i will use tmc2208?
Ok...so where do i need to change the pins...in marlin 2.0, under pins_RADDS.h?
I will use the available pins from max endstop,or from lcd connector that is on radds...because i don't planing to use lcd...or if i will use lcd...i have the aux1 pins available as well..that aux1 pins on radds is for adding the extra extruders with the expansion board v2 or v3
so my question is that i have to activate serial in marlin...or only need to assign the tx and rx pin for each axis where i will use tmc2208?
