Do you have #define Z_HOMING_SENSITIVITY 8 enabled in Configuration_adv.h ?
I noticed in earlier releases the z axis isn’t commented in the sensorless homing section. I’m having my own different issues with the same drivers on the same board. I don’t get any errors or anything from m122 to point in the right direction but I can’t get any axis to move or home. I’ll make a new thread for my own issues though.
I noticed in earlier releases the z axis isn’t commented in the sensorless homing section. I’m having my own different issues with the same drivers on the same board. I don’t get any errors or anything from m122 to point in the right direction but I can’t get any axis to move or home. I’ll make a new thread for my own issues though.