I find that I have to enable the Bed Leveling in the Slicer like so M420 S1 ; Bed Leveling on.
these are the last 3 line in my slicers startup G-Code.
G92 E0 ;reset extruder length
M420 S1 ; Bed Leveling On
M220 S32.000000
If I do not enable the Bed leveling data I also crash into the Bed on occasions.
these are the last 3 line in my slicers startup G-Code.
G92 E0 ;reset extruder length
M420 S1 ; Bed Leveling On
M220 S32.000000
If I do not enable the Bed leveling data I also crash into the Bed on occasions.