I have been trying to generate firmware for my printer for two days now, and I am about to start pulling out my hair, very frustrated. I have tried the Marlin config tool, editingn manually in Notepad++, and even resorted to using questionable firmware I have found on Thingiverse and google, and nothing is working, I get random errors while trying to compile the firmware and I am tired of chasing my tail here. I have a Wanhao Duplicator i3 with 200mm (x) by 300mm (y) bed, recently upgraded to RAMPS 1.4 +RepRap Full Graphics LCD (tried to get it working with Repetier but no luck there either) and BLTouch installed. My offsets for the sensor are X: 41mm Y: 46mm and Z: 1mm. I can provide any other info needed.
I am uploading my current configuration here: [www.dropbox.com]
Here is my current Configuration.h via pastebin: [pastebin.com] (I took out SD card support on this, but now my SD slot is not working (duh)) Also my steppers are not moving with this configuration.
My current error appears to have something to do with enabling SD card support (which I am assuming I need) I will paste it below. Can someone please take a look make any corrections needed and give me a version that will work, or at least get me headed in the right direction? Thank you in advance
Current error message via pastebin: [pastebin.com]
I am uploading my current configuration here: [www.dropbox.com]
Here is my current Configuration.h via pastebin: [pastebin.com] (I took out SD card support on this, but now my SD slot is not working (duh)) Also my steppers are not moving with this configuration.
My current error appears to have something to do with enabling SD card support (which I am assuming I need) I will paste it below. Can someone please take a look make any corrections needed and give me a version that will work, or at least get me headed in the right direction? Thank you in advance
Current error message via pastebin: [pastebin.com]