Hi!
I soldered a two-wire-cable to the reset button at the RAMPS (could be done to the Arduino as well) and put a flat push-button on the other cable's end. I glued the button just beside the Stop-Button on the LCD. So I can stop and reset the printer now from the LCD. ;-)
I also made a change to the Arduino itself to disable the soft-reset during a serial connection via USB:
I truncated the REST-EN pad and soldered also a two-wire-cable leading to an on/off-switch which I placed on the front of the Printer-Box. Now I can switch the arduino to "PROG" or "RUN"-mode
Cheers
Knut
I soldered a two-wire-cable to the reset button at the RAMPS (could be done to the Arduino as well) and put a flat push-button on the other cable's end. I glued the button just beside the Stop-Button on the LCD. So I can stop and reset the printer now from the LCD. ;-)
I also made a change to the Arduino itself to disable the soft-reset during a serial connection via USB:
I truncated the REST-EN pad and soldered also a two-wire-cable leading to an on/off-switch which I placed on the front of the Printer-Box. Now I can switch the arduino to "PROG" or "RUN"-mode
Cheers
Knut