Still struggling with this .....
An interesting observation though:
On a CR-10S with a 300 * 300 physical bed and a BLTouch
Bed is set at 300 * 300. Mesh max x is 300 mesh max y is 300
I set the probe offset to x0 and y 0 !!!!
The points probed are:
150/150
75/150
150/75
225/150
150/225
75/225
75/75
225/75
225/225
For some reason (and I suspect a bug), the automatic probing never ends up at x or y zero nor at x or y 300 !!!
It seems to me that if I have specified that the probe is at the same position as the extruder and that the extruder can cover from 0 to 300 in both axis, the probing routine should include x0 x300 y0 and y300 ....
Could somebody give me a reason why the autoprobing should not cover the extreme ends of the bed ?
An interesting observation though:
On a CR-10S with a 300 * 300 physical bed and a BLTouch
Bed is set at 300 * 300. Mesh max x is 300 mesh max y is 300
I set the probe offset to x0 and y 0 !!!!
The points probed are:
150/150
75/150
150/75
225/150
150/225
75/225
75/75
225/75
225/225
For some reason (and I suspect a bug), the automatic probing never ends up at x or y zero nor at x or y 300 !!!
It seems to me that if I have specified that the probe is at the same position as the extruder and that the extruder can cover from 0 to 300 in both axis, the probing routine should include x0 x300 y0 and y300 ....
Could somebody give me a reason why the autoprobing should not cover the extreme ends of the bed ?