Re: Move an axis to a position when print is done?

I'd think when Cura or Repetier sends a m104 and an M84 at the end of a print cycle it could be possible to execute a command within the firmware to send the printer bed to a forward position. The reason I believe this is because I purchased one of those cheap cube style Chinese 3d printers called an Instone Easier Mini (also known as an Aladdin Skycube) and before I created my own version of Marlin to replace the firmware that was loaded onto the board from the manufacturer it actually did raise the Z axis slightly and then move the Y axis forward until it hit the endstop. I was told the original firmware on this printer was an older version of Repetier. Isn't Repetier based off of the original Marlin firmware? I hope someone can chime in on this because I really do think it's possible.

In the meantime I will just have to use gcode to do so.

Thanks :)