Yep have the MB selected correctly and everything.. and by default those pins are called out for the einsy_board, aren't they.. I double checked everything and they are there...(attached file)
is there anything in the config file that I have to set up, that would flag that error? for example when you set the board and don't configure the TMC drivers?
If I comment out the BLtouch everything compiles just fine...
is there anything in the config file that I have to set up, that would flag that error? for example when you set the board and don't configure the TMC drivers?
If I comment out the BLtouch everything compiles just fine...