Quote
Dust
if your running a random configuration from facebook, who knows what that has set...
Gotcha. However, it wasn't random. It was on the Hypercube Evolution, posted by someone who is using it.I figured it was easiest to use that as a base.
Quote
Dust
the motherboard (reprap controller) needs to match your motherboard
Could be a problem, I'll have to check it out to see if the fellow that supplied it uses a Mega2560/RAMPS. I think he does.
Quote
Dust
corexy needs to be enabled
It is. I also looked over all the settings, referring to some guides on RAMPS setup.
Quote
Dust
yes you need endstops as most printers are setup so if the endstops are disconnected they are triggered, so you have all endstops triggerd so nothing will move.
This is likely the problem. I had not considered that. Thanks.
Quote
Dust
And yes you need to home so it knows where it is, otherwise power on is 0 and it wont move -ve past that point
Right. I thought I could get it moving by centering the x/y manually, sending a G92 to set all axis positions to 0, then moving in small increments. But again, it's likely the endstops not being connected.
While trying to get things moving, I could not get the X or Y steppers to move, and wondered about homing. Tried it with Repetier, and heard some soft chirping sounds that turned out to be the piezo element on the display. Not sure what that meant, so I pressed the stop button on the display while it was chirping. The puff of smoke was a surprise, to say the least. I'm not sure if it fried the RAMPS board, but the 2560 is toast. I have another 2560, so I'll try it with the RAMPS, but leave the display off.
I may just go for a Duet WiFi or Smoothieboard