I am starting with a fresh copy of BugFix 1.1
With the following enabled, Home All stops at each end stop.
#define BED_CENTER_AT_0_0
When I send G0 X0 Y0, X is about 60mm toward the bed center from the left edge of the bed, or 190mm from what it thinks is 0. Y is about right at 108mm from front edge toward the center.
Am I on the right track? How do I get it to properly center before I attempt the cube?
With the following enabled, Home All stops at each end stop.
#define BED_CENTER_AT_0_0
When I send G0 X0 Y0, X is about 60mm toward the bed center from the left edge of the bed, or 190mm from what it thinks is 0. Y is about right at 108mm from front edge toward the center.
Am I on the right track? How do I get it to properly center before I attempt the cube?