The good news: Setting PROBE_BED_POSITION allowed it to upload. However, as I have no idea how to determine the parameters, they are undoubtedly wholly inaccurate.
The bad news: The BL Touch opitions on the menu don't seem to do anything My printer homes to the middle of the bed and nowhere near the surface. It doesn't seem to print anything anymore
I think I missed out on centering the printer (https://github.com/JimBrown/MarlinTarantula/wiki/How-to-center-your-prints-(EasyConfig)) and am trying to do that but I get a BT Touch error telling me to restart with M999
Any suggestions? Should I just start again with a clean configuration.h?
PS If anyone is curious how far I can throw a Tevo Tarantula, watch this space! :-(
The bad news: The BL Touch opitions on the menu don't seem to do anything My printer homes to the middle of the bed and nowhere near the surface. It doesn't seem to print anything anymore
I think I missed out on centering the printer (https://github.com/JimBrown/MarlinTarantula/wiki/How-to-center-your-prints-(EasyConfig)) and am trying to do that but I get a BT Touch error telling me to restart with M999
Any suggestions? Should I just start again with a clean configuration.h?
PS If anyone is curious how far I can throw a Tevo Tarantula, watch this space! :-(