Hi guys,
I've replaced my printers board with a RAMP 1.4 and Marlin 1.1.8.
I've put the TMC2130 drivers on, on all axis (including extruder).
Everything seem to be working, except my extruder.
When I run it, in both directions, it simply stutters for the duration of the extrude but doesn't move backwards or forwards. Just back and forth, over and over. This happens without filament in it, so it's not due to any clogs.
I've tried adjusting the current to the extruder, with M906 Exxx all the way from 500 to 1600, with no changes. I am running 800 on all the other drivers.
I'm posting this in the Marlin forum as I have a feeling it is a misconfiguration by me, somewhere in the firmware, but I have no clue where to look.
I've also tried to adjust axis relative modes on the extruder, with no change.
So does this sound familiar to anyone?
I've replaced my printers board with a RAMP 1.4 and Marlin 1.1.8.
I've put the TMC2130 drivers on, on all axis (including extruder).
Everything seem to be working, except my extruder.
When I run it, in both directions, it simply stutters for the duration of the extrude but doesn't move backwards or forwards. Just back and forth, over and over. This happens without filament in it, so it's not due to any clogs.
I've tried adjusting the current to the extruder, with M906 Exxx all the way from 500 to 1600, with no changes. I am running 800 on all the other drivers.
I'm posting this in the Marlin forum as I have a feeling it is a misconfiguration by me, somewhere in the firmware, but I have no clue where to look.
I've also tried to adjust axis relative modes on the extruder, with no change.
So does this sound familiar to anyone?