Quote
Roxy
When you made changes to:
#define DEFAULT_AXIS_STEPS_PER_UNIT { 80, 80, 400, 94.4962144 }
Did you do a M502 and M500 to get the new values stored in EEPROM? If not... you won't see any changes.
Hi Roxy,
I did try it in the first instance but didn't seem to take affect (used the console in Cura), I have however retried uploading the settings and running in Repetier and it's taken effect!
Is there somewhere in the settings I can get the probe points to move in a little closer? I've got my probe on the right hand side of the hot end so by probing point number 3 it's just off the bed so wouldn't make metal contact. I need it in by about 10mm