Hi Guys,
Please help me because I'm very sad for the results.
I bought the Kossel Pro from renren3d with Marlin firmware and the printer is very good, but I have many many problem with the autoleveling process.
The renren3d technical assistance is very bad, there is a forum but never replied regarding my problem. Following the Kossel Pro manual, there is a Autoleveling procedure but doesn't work correctly.
The manual provides self-detection based on 3 points, but it does not work at all, it is a useless calibration.
Please can you help me for to insert inside my firmware a "strong" solution for autoleveling?
In attach the original manual with the autoleveling procedure:
Image "Autoleveling.jpg and Autoleveling2.jpg"
Auto leveling device:
Image "Microswitch.jpg"
Only in the Bed Center is perfect the printer:
Image "CenterOk.jpg"
On the left side it crushes too much and does not come out of the plastic, while on the right side it is too high:
Image "Left&Right.jpg and Right.jpg"
Below my Marlin Firmware folder:
[www.dropbox.com]
Please I want a "strong" solution for autoleveling process, I can not print a perfect circle
Thanks.
Federico.
Please help me because I'm very sad for the results.
I bought the Kossel Pro from renren3d with Marlin firmware and the printer is very good, but I have many many problem with the autoleveling process.
The renren3d technical assistance is very bad, there is a forum but never replied regarding my problem. Following the Kossel Pro manual, there is a Autoleveling procedure but doesn't work correctly.
The manual provides self-detection based on 3 points, but it does not work at all, it is a useless calibration.
Please can you help me for to insert inside my firmware a "strong" solution for autoleveling?
In attach the original manual with the autoleveling procedure:
Image "Autoleveling.jpg and Autoleveling2.jpg"
Auto leveling device:
Image "Microswitch.jpg"
Only in the Bed Center is perfect the printer:
Image "CenterOk.jpg"
On the left side it crushes too much and does not come out of the plastic, while on the right side it is too high:
Image "Left&Right.jpg and Right.jpg"
Below my Marlin Firmware folder:
[www.dropbox.com]
Please I want a "strong" solution for autoleveling process, I can not print a perfect circle
Thanks.
Federico.