Quantcast
Channel: Reprap Forum - Firmware - Marlin
Viewing all articles
Browse latest Browse all 12090

Re: unified bed leveling resulting in Z-height issue

$
0
0
Quote
auggie246
Yes my Z_PROBE_OFFSET_FROM_EXTRUDER is at a number which when I do G1 Z0, my nozzle barely touches the bed. However after I do a G29 P1. my mean mesh is around -0.9

G29 T gives
Bed Topography Report:

Yes. But if that was true... There should be some mesh point on that Topography map that is close to 0.00 mm. Your Z-Probe_Offset_From-Extruder is not right. All of the bed leveling systems use the exact same low level probing system. This part of the code probably works...

Viewing all articles
Browse latest Browse all 12090

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>