Quote
stephenrc
I didn't notice that they added more RAMPS definitions. I was using BOARD_RAMPS_13_EFB and changed it to BOARD_RAMPS_14_EFB. The servo now work on servo 0. The wiki says the only difference between 1.3 and 1.4 is that 1.4 uses surface mount compnents. Why does that affect the servo?
More changed than the fact they are using surface mount components. I know there were a lot of issues with stuff not working when the new version of the board came out. I think if you compare the two Pins.h files you will find all of the stuff (that we know about right now) that changed. I don't know the details. I don't have a RAMP's board. But I do know it caused a lot of head aches.
Would you mind updating the first post in this thread to say Marlin 1.1.0 RC3 is ok with RAMP's if the correct version of the board is selected? I don't want people to be hesitant to use RC3. RC3 is clearly the most stable version of Marlin in the last few years. Support issues will be much less if we can get people to migrate to it.