Re: Marlin Configuration

Ok so I had Arduino 1.0.5 and 1.6.9 so changing to 1.8.5 seems to have fixed the issue. However now I am getting this:

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00
An error occurred while uploading the sketch

I have selected Sanguino w/ ATmega1284 (16MHz) on COM3 (which is all correct) so cannot work out why I am getting this issue.

Note: So it had been working on Arduino 1.0.5 with an older version of Marlin using ATmega1284 however I noticed the board itself said ATmega644P, so I tried with that and still the same issue.