Hello good people.
Yep, i got cheap 3d printer, it works(ish).
Decided to flash it to marlin as mine came with hell knows what.
Problem is i dont know some of bits that are on this printer to get config going. Dont want to break/brick it.
Namely hot end and bed heater/sensor specs.
Is there any way to check current settings under the hood so i could carry them over to marlin ?
The board is GT2560 Rev A. very few menu options, nothing for tuning/setup. Basic to say the least.
This is the printer. CTC branded.
[www.ebay.co.uk]
Any ideas how to proceed ?
Yep, i got cheap 3d printer, it works(ish).
Decided to flash it to marlin as mine came with hell knows what.
Problem is i dont know some of bits that are on this printer to get config going. Dont want to break/brick it.
Namely hot end and bed heater/sensor specs.
Is there any way to check current settings under the hood so i could carry them over to marlin ?
The board is GT2560 Rev A. very few menu options, nothing for tuning/setup. Basic to say the least.
This is the printer. CTC branded.
[www.ebay.co.uk]
Any ideas how to proceed ?