I am using a TL-W3MC2 using a Operating voltage range 10 to 30 VDC sensor which is powered with 5V, 1st sensor a SN04-N 6V was too bulky.
[www.ia.omron.com]
I have stopped at Marlin 1.1.5 temporally, as I had problems with Marlin 1.1.6 flashing weird, not working and almost bricking controller.
Not actually blaming Marlin 1.1.6 just made me nervous and returned to 1.1.5 as it was working best of all versions, with the features I liked and used.
Bed Leveling Bi-linear (allows saving Bed Leveling Data ( M500 or "LCD Menu" Store settings and restore using M420 S1 in startup G-Code )
Baby-stepping ( allows for quick adjustments to Z-Offset height adjustment during brim if needed )
Individual Axis Home Menu
Your setting seem to be the same as mine.
Link to my working Marlin_Blue.zip this is Marlin 1.1.5 here
Compare My Settings to Yours Configuration.h, Configuration_adv.h and Pins_RAMPS.h
[www.ia.omron.com]
I have stopped at Marlin 1.1.5 temporally, as I had problems with Marlin 1.1.6 flashing weird, not working and almost bricking controller.
Not actually blaming Marlin 1.1.6 just made me nervous and returned to 1.1.5 as it was working best of all versions, with the features I liked and used.
Bed Leveling Bi-linear (allows saving Bed Leveling Data ( M500 or "LCD Menu" Store settings and restore using M420 S1 in startup G-Code )
Baby-stepping ( allows for quick adjustments to Z-Offset height adjustment during brim if needed )
Individual Axis Home Menu
Your setting seem to be the same as mine.
Link to my working Marlin_Blue.zip this is Marlin 1.1.5 here
Compare My Settings to Yours Configuration.h, Configuration_adv.h and Pins_RAMPS.h