Pronter face and I can use its buttons or go to console and do it and the outcome is the same. G28 is not saving the position of Z so it never knows where it is else it would be working as it should where Z never moves up after the first G28. I told Roxy about this but I have no idea what is happening as he never got back to me on github. It was he who suggested for me to try it as Z will not move up again after the first G28 since it will know it is high enough but it didn't follow that logic.Quote
Roberts_Clif
Marlin 1.1.5
Connected to Cura 15.04.6 - Pronterface send the Following.
G28 ; did complete home X, Y, and Z
G28 X/Y ; did Home X and Home Y
G28 X/Y/Z ; did complete Home X, Y, and Z
What method are you using to connect to your 3D Printers.
↧
Re: 1.1.6
↧