When I upgraded to Marlin 1.1.6, opened both my RC6 and the new 1.1.6 in half screen mode and went thru one line at a time until all changes were copied across.
In Configuration.h, Configuration_adv.h and pins_Ramps.h there were many new elements that I bypassed until proving that Marlin worked.
Then I saved-As under Marlin_1.1.6 after making other changes were made saved-As under Marlin_1.1.6_BB (for Baby Stepping) Marlin_1.1.6_FR (For filament run_out) ect.
Need help Upload your 3D Printer Configuration.h file will have a look to see what happened. Where did you download 1.1.6 from if not from github.
In Configuration.h, Configuration_adv.h and pins_Ramps.h there were many new elements that I bypassed until proving that Marlin worked.
Then I saved-As under Marlin_1.1.6 after making other changes were made saved-As under Marlin_1.1.6_BB (for Baby Stepping) Marlin_1.1.6_FR (For filament run_out) ect.
Need help Upload your 3D Printer Configuration.h file will have a look to see what happened. Where did you download 1.1.6 from if not from github.