Re: Auto Bed Leveling doubt

Hi Roxy,

Thanks once again for your support.

I am pretty sure my endtops are working properly. They were before the M502/500 command but maybe this is not what you meant.

What I can not understand is why the software seems to consider the Z-Max Endstop as the Min. I assume this is the reason why the Z axis begins to move downards to the table and, as soon as the Z-Max Endstop is not active, it comes back and resume to the next point. Homing Z works perfectly.

I am using a 3 point Automatic Bed Leveling.

Forgive me if I misunderstood something.

Thanks!

Marcus