Okay so if min_software_endstops is disabled then what does the z probe offset do? Will it lower the head that distance before printing begins?
If this is the way it works then I will try it and then go with two options. 1) leave min_software_endstops off and measure the offset and enter it into z_ probe offset in marlin. Or 2) with min_software_endstops enabled. Leave z probe offset set to 0 and enter the offset in slicer, or using m851 or Lcd.
Sound right?
If this is the way it works then I will try it and then go with two options. 1) leave min_software_endstops off and measure the offset and enter it into z_ probe offset in marlin. Or 2) with min_software_endstops enabled. Leave z probe offset set to 0 and enter the offset in slicer, or using m851 or Lcd.
Sound right?