what is your bed temp and hot end temp?
have you calibrated your printer axis and extrusion?
are you sure the slicer has the correct tip size?
I see 'elephant foot' that makes me think your bed is too hot, the layer adhesion often can be several issues from cold extrusion to under extrusion etc
do you have a fan on your hotend to cool extrusion as deposited?
I use this setup on mine:
[www.thingiverse.com]
have you calibrated your printer axis and extrusion?
are you sure the slicer has the correct tip size?
I see 'elephant foot' that makes me think your bed is too hot, the layer adhesion often can be several issues from cold extrusion to under extrusion etc
do you have a fan on your hotend to cool extrusion as deposited?
I use this setup on mine:
[www.thingiverse.com]