I measured resistance from my cfg 1 pin to gnd and proved I have a pull down resistor in place on my Ramps board so cant be in stealthChop.....
I am running 1.3v on most of my steppers but y-axis has a smaller motor and I have to push it to 1.37v, my extruder is at 1.45v
Nothing over heats, my motors all stay good with the hottest one running 41c after a 6hr print.
I am running 1.3v on most of my steppers but y-axis has a smaller motor and I have to push it to 1.37v, my extruder is at 1.45v
Nothing over heats, my motors all stay good with the hottest one running 41c after a 6hr print.