I have the exact ones in the picture:
It actually depends on your controller. Many controllers come with a pull down resistor on CFG 1 so these will run as 1/16 microstep with 1/256 interpolation in spreadCycle mode on a Ramps 1.4 or MKS Gen 1.4 by simply pulling all three jumpers.
IF you have another board you may have to figure them out based on how your board configures the three CFG pins....
BTW this forum is for Marlin Firmware questions, this is a hardware question :)
It actually depends on your controller. Many controllers come with a pull down resistor on CFG 1 so these will run as 1/16 microstep with 1/256 interpolation in spreadCycle mode on a Ramps 1.4 or MKS Gen 1.4 by simply pulling all three jumpers.
IF you have another board you may have to figure them out based on how your board configures the three CFG pins....
BTW this forum is for Marlin Firmware questions, this is a hardware question :)