First I must apologize for asking a question when I haven't yet tried Marlin and have spent only about an hour reading about it and viewing the source code.
My question is, when Z probing, is there a way of having a short delay between each movement in the XY plane and the Z down movement? The delay would have to be something of the order of 100ms.
The significance of my question is that I have been working on a piezoelectric sensor for bed leveling and the sensor picks up the shake at the end of an XY movement. If the output of the sensor is sampling at this time it will be falsely triggered. Details of this sensor on [www.thingiverse.com]
Thanks for any help you can give,
Mike
My question is, when Z probing, is there a way of having a short delay between each movement in the XY plane and the Z down movement? The delay would have to be something of the order of 100ms.
The significance of my question is that I have been working on a piezoelectric sensor for bed leveling and the sensor picks up the shake at the end of an XY movement. If the output of the sensor is sampling at this time it will be falsely triggered. Details of this sensor on [www.thingiverse.com]
Thanks for any help you can give,
Mike