Hi!
I'm assembling a Kossel XL, using an Arduino Mega, a RAMPS 1.4 Board, and Marlin.
connecting the Arduino to the computer is fine, Display shows normal temepratures around 37°C
But as soon as I power up the main power supply, the temperature on the display starts rising, reaching 300°C and a MAXTEMP Error after ~3min. It keeps rising afterwards, until I unplug the power.
Is this a Marlin Issue, and if it is, does any of you guys know what might cause it? If I missed some information, please ask, I'm just new to the Topic.
best regards,
Arved
PS: because I'm not sure where the problem lies, I also posted this in the RAMPS forum.
I'm assembling a Kossel XL, using an Arduino Mega, a RAMPS 1.4 Board, and Marlin.
connecting the Arduino to the computer is fine, Display shows normal temepratures around 37°C
But as soon as I power up the main power supply, the temperature on the display starts rising, reaching 300°C and a MAXTEMP Error after ~3min. It keeps rising afterwards, until I unplug the power.
Is this a Marlin Issue, and if it is, does any of you guys know what might cause it? If I missed some information, please ask, I'm just new to the Topic.
best regards,
Arved
PS: because I'm not sure where the problem lies, I also posted this in the RAMPS forum.