There is not enough room in the cube frame to install a probe that I can work out yet.
I would loose some build space if I put it beside the head (Either side), my fan is in front and built to actually go under the front of the frame and stick out of the cube.
I am looking at a way to put it in between the rails behind the head.... but that's looking to be a fairly major redesign....
Building a new 275x250mm printer in the coming months so I am fairly likely to leave this little 150x130mm cube as it is now, as a spare to pop smaller things out.
I would loose some build space if I put it beside the head (Either side), my fan is in front and built to actually go under the front of the frame and stick out of the cube.
I am looking at a way to put it in between the rails behind the head.... but that's looking to be a fairly major redesign....
Building a new 275x250mm printer in the coming months so I am fairly likely to leave this little 150x130mm cube as it is now, as a spare to pop smaller things out.