Quote
Roberts_Clif
// The Z probe minimum outer margin (to validate G29 parameters).
#define MIN_PROBE_EDGE 10
I don't quite understand the comment. What does the MIN_PROBE_EDGE do?
Also, I thought a read somewhere here in the forums that there is a setting that defines how high the nozzle is raised when probing a point. From the looks of it in the discussion, it made sure you didn't start with the nozzle pressed into the bed and allowed you to just lower the nozzle to the right height. But I can't seem to find it in the code. I was wondering if MIN_PROBE_EDGE might have been the setting or did that setting get deprecated in a new version of Marlin?
gene