Hi
I have Marlin firmware and have read the M commands on the wiki on this page - [reprap.org]. I use Repetier host software to print
There are only M [500, 501, 502] commands to store settings into EEPROM and to read settings from EEPROM into the printer.
Is there any way of finding out what exactly the current EEPORM settings are?
What I would like to do is issue a command in Repetier that will read my EEPROM saved settings and display them onscreen or in some log file.
The reason I want to do this is to have like a backup of these settings to revert to in case I mess up and store some wrong setting in EEPROM.
Is there such a command?
Will M503 do this for me?
I have Marlin firmware and have read the M commands on the wiki on this page - [reprap.org]. I use Repetier host software to print
There are only M [500, 501, 502] commands to store settings into EEPROM and to read settings from EEPROM into the printer.
Is there any way of finding out what exactly the current EEPORM settings are?
What I would like to do is issue a command in Repetier that will read my EEPROM saved settings and display them onscreen or in some log file.
The reason I want to do this is to have like a backup of these settings to revert to in case I mess up and store some wrong setting in EEPROM.
Is there such a command?
Will M503 do this for me?