Hey guys,
I recently upgraded to an e3d v6 and bumped up the temperature limit to 295C. Whenever I try to heat beyond 260C it shows printer halted, heating failed. Even though I managed to PID autotune at 285 before. The heater which throws the error is my extruder(not my heated bed) and despite changing the wiring to a coarse 12guage wire it still throws the same error. Is there some setting im not aware of ?
I recently upgraded to an e3d v6 and bumped up the temperature limit to 295C. Whenever I try to heat beyond 260C it shows printer halted, heating failed. Even though I managed to PID autotune at 285 before. The heater which throws the error is my extruder(not my heated bed) and despite changing the wiring to a coarse 12guage wire it still throws the same error. Is there some setting im not aware of ?