Thanks for the response, thankfully at 2am this morning I have resolved the issue somewhat. So I figured out that the axis direction on both the config h basic and adv needed to match up which resolved my issue. However, now that it's solved I went ahead and calculated and adjusted the Esteps needed to make a full mm of movement and set the homing speed which was TOO fast. I have the homing speed set to 30mm/s which is kinda slow but still works EXCEPT when I send a job. It goes to home endstop bumps the second time then it tries to skyrocket to what I guess is the starting print hieght, to which it skips steps dramatically. I lowered the acceleration rate down to match the homing speed of 30mm/s but again right after the slow n steady homing process it tries to zoom to its next height. I also lowered the print speed to 40mm/s in repetier host but still to no avail! Any ideas? Thanks again.
↧