I can confirm the issue with the SD card and screen. I am working on a custom Marlin for the Ender-2 when I found this out. Too bad I did not search here beforehand.
Also a custom _bootscreen.h is all garbled up.
Trying to use slower spi speeds for SD reader in firmware gave no solution.
Wiki for this lcd type is not very helpful either...
Any of you found a solution in the meantime?
Also a custom _bootscreen.h is all garbled up.
Trying to use slower spi speeds for SD reader in firmware gave no solution.
Wiki for this lcd type is not very helpful either...
Any of you found a solution in the meantime?