Hi guys, i hope you can help. I setup my printer with marlin 1.1.4 and BLtouch. The printer homes and then auto levels fine. When it comes to print it is printing above the print bed.
When my printer homes in homes then rests 10mm above the bed after i put my offset in and it seems like its going down the offset but thinking the 10mm hold is the bed level? any ideas please here is config.
When my printer homes in homes then rests 10mm above the bed after i put my offset in and it seems like its going down the offset but thinking the 10mm hold is the bed level? any ideas please here is config.