Dear All,
I have a problem about configuring Marlin for dual extruders.
Two of my extruders are exactly same (NEMA 17 associated with 5:1 Geared box).
I configured them as same parameters in Marlin (please see the attached file),
Unfortunately, they did not run same when I tested them by Repetier-host.
Extruder 1 is OK, but Extruder 2 seem run faster.
I am curious that the extruders which were configured by same parameters did have same running.
I have a problem about configuring Marlin for dual extruders.
Two of my extruders are exactly same (NEMA 17 associated with 5:1 Geared box).
I configured them as same parameters in Marlin (please see the attached file),
Unfortunately, they did not run same when I tested them by Repetier-host.
Extruder 1 is OK, but Extruder 2 seem run faster.
I am curious that the extruders which were configured by same parameters did have same running.