Re: Porous prints on larger prints

No tension screw to tighten. Very basic spring loaded tension device. The Vref is set at about 5.1. Motor is running at about 115 F.

Here is my current settings:

SENDING:M501
echo:V27 stored settings retrieved (398 bytes)
echo:Steps per unit:
echo: M92 X80.00 Y80.00 Z400.00 E111.00
echo:Maximum feedrates (mm/s):
echo: M203 X14.00 Y14.00 Z5.00 E35.00
echo:Maximum Acceleration (mm/s2):
echo: M201 X3000 Y3000 Z100 E10000
echo:Accelerations: P=printing, R=retract and T=travel
echo: M204 P100.00 R200.00 T200.00
echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s)
echo: M205 S0.00 T2000.00 B20000 X20.00 Y20.00 Z0.40 E5.00
echo:Home offset (mm)
echo: M206 X0.00 Y0.00 Z0.00
echo:Material heatup parameters:
echo: M145 S0 H180 B70 F255
M145 S1 H240 B110 F0
echo:PID settings:
echo: M301 P30.47 I1.86 D125.02
echo: M304 P435.90 I85.28 D557.02
echo:Filament settings: Disabled
echo: M200 D3.00
echo: M200 D0

Left M92 E at 111.

I've set M203 x,y to 14 and E to 35

I'm running a print now but have set the flowrate and feed rate back to 90% and it is faster and not doing the slipping. (See JPG attached)