I noticed today. That when trying a print the LCD display flashed E1 Heating. Now, I *know* I only have one extruder defined in Configuration.h.
Could the printer be trying to extrude through a non existent extruder?
Pro's.
It would explain why the extrusion test performed on the LCD works since it specifies E0 as extruder.
The MKS Gen 1.4 card does have a second extruder. Does this need to be disabled if not being used?
Con's
A non existent extruder should give error message as min printing temp (170) has not been reached.
Config.h has one extruder defined
All non used thermistors are stated as ) non used in config.h so should be getting errors that non existent thermistors are undefined.
Could the printer be trying to extrude through a non existent extruder?
Pro's.
It would explain why the extrusion test performed on the LCD works since it specifies E0 as extruder.
The MKS Gen 1.4 card does have a second extruder. Does this need to be disabled if not being used?
Con's
A non existent extruder should give error message as min printing temp (170) has not been reached.
Config.h has one extruder defined
All non used thermistors are stated as ) non used in config.h so should be getting errors that non existent thermistors are undefined.