I'm using DRV8825's as my stepper drivers.
The config page I used to config them said since they were 1/32 rather than 1/16 microsteppers so I had to double my values.
I tested them with the original values (80,80,400,206) the attempted test print was half size, when I used (160,160,800,206)
The print was full size.
Probably more luck than skill..:) When I can get a proper test print I'll calibrate further.
Any ideas on the extrusion issue?
The config page I used to config them said since they were 1/32 rather than 1/16 microsteppers so I had to double my values.
I tested them with the original values (80,80,400,206) the attempted test print was half size, when I used (160,160,800,206)
The print was full size.
Probably more luck than skill..:) When I can get a proper test print I'll calibrate further.
Any ideas on the extrusion issue?