If you have your X-Axis homing correctly... There is no reason to change it. But the FolgerTech instructions had people putting the X-Endstop on the X-Min and putting it on the right side. That was causing a lot of confusion.
On the E-Steps... Go with what you have. Yours very possibly is 'correct'.
On the non-existent Z-Probe... It is a little bit tricky but it is possible to have a Z-Probe and still use the Z-Min endstop for homing. That is what you need to get to work. Later when you get your servo and micro switch and get that bracket printed up, you can install a real Z-Probe. (Oh! You also need the longer M3 screws --- It might be good to take one screw out just so you can measure it. You need 5mm more than what is in there now.)
On the E-Steps... Go with what you have. Yours very possibly is 'correct'.
On the non-existent Z-Probe... It is a little bit tricky but it is possible to have a Z-Probe and still use the Z-Min endstop for homing. That is what you need to get to work. Later when you get your servo and micro switch and get that bracket printed up, you can install a real Z-Probe. (Oh! You also need the longer M3 screws --- It might be good to take one screw out just so you can measure it. You need 5mm more than what is in there now.)
