Hello everyone,
I am trying to change the current Reprap discount display (20x4) display, to a Noritake CU24043-Y1A, VFD display. I like the look of VFD, and I have had this display for a few years now. I do not have any concern about the hardware setup, but I am having trouble with changing the marlin firmware to control the display. I am not looking for anything special, just the same stuff the reprap display would normally show. I can read some "C" programming, but I cant write it yet (still learning).
Would someone be able to help me out with the firmware, so I can use this VFD display?
I have included the datasheet, and the Arduino library for this display, that was created by Noritake.
Arduino Library (Select the "CU-Y Series" tab)
Datasheet
Thank you
TC
I am trying to change the current Reprap discount display (20x4) display, to a Noritake CU24043-Y1A, VFD display. I like the look of VFD, and I have had this display for a few years now. I do not have any concern about the hardware setup, but I am having trouble with changing the marlin firmware to control the display. I am not looking for anything special, just the same stuff the reprap display would normally show. I can read some "C" programming, but I cant write it yet (still learning).
Would someone be able to help me out with the firmware, so I can use this VFD display?
I have included the datasheet, and the Arduino library for this display, that was created by Noritake.
Arduino Library (Select the "CU-Y Series" tab)
Datasheet
Thank you
TC