Quote
DOYT
I want my button from LCD panel to act like the reset button mounted on the ramps board.
You and me both! I would trust a hard wired reset button much more than one that relies on the firmware doing everything correctly and being alive.
But... The Kill button on the LCD isn't wired that way. And in fact.... There isn't even a Reset pin you can connect a switch up to on the RAMPS board. I soldered a wire onto the reset switch and ran it to a big red switch I can press quickly if the printer is in danger of hurting itself. (I need that much more than the causal user. But still... I think the RAMPS board should bring the reset switch out to a connector.)