That's why you go thru the calibration process. The calculations that you are doing are just a starting point.
There are several things that can make the calculated value be incorrect. One of them is pressure that the
spring exits on the filament, another would be the actual diameter of the gear that the filament passes over
verses the designed diameter. So even though your calculations may be correct the calculated value may
be off but it is a good starting point.
Good luck with your prints.
There are several things that can make the calculated value be incorrect. One of them is pressure that the
spring exits on the filament, another would be the actual diameter of the gear that the filament passes over
verses the designed diameter. So even though your calculations may be correct the calculated value may
be off but it is a good starting point.
Good luck with your prints.