Hi,
Does anyone have an up to date set-up procedure for bed levelling on the current Marlin.
I have been going around in circles for days now (insane :))....
I have followed Thomas Sanderer's video on YouTube, but when I get to the final calibration part I cannot for the life of me get the probe to go below the sensor trigger point.
Sorry if this a simple question....
Mark
Was using Repetier Host works in Ponterface...:)
Does anyone have an up to date set-up procedure for bed levelling on the current Marlin.
I have been going around in circles for days now (insane :))....
I have followed Thomas Sanderer's video on YouTube, but when I get to the final calibration part I cannot for the life of me get the probe to go below the sensor trigger point.
Sorry if this a simple question....
Mark
Was using Repetier Host works in Ponterface...:)