Yea, I get that, there is a lot of chatter about this on the Marlin Github.
Unfortunately it seems more printer manufacturers are moving to the GD chipset (I guess they are cheaper than the ARM ST32 chipset), so sooner or later I feel the Marlin dev's will have to address them :S. At the moment however most conversations around GD32 seem to be shutdown with a "Do not support" :(
Saying that, I did think I should check the pull requests for GD32 support and there are a few open that seem to address some of the issues I am getting and found a few that are in the works:
[github.com]
[github.com]
I guess I have a bit of reading to do!
Unfortunately it seems more printer manufacturers are moving to the GD chipset (I guess they are cheaper than the ARM ST32 chipset), so sooner or later I feel the Marlin dev's will have to address them :S. At the moment however most conversations around GD32 seem to be shutdown with a "Do not support" :(
Saying that, I did think I should check the pull requests for GD32 support and there are a few open that seem to address some of the issues I am getting and found a few that are in the works:
[github.com]
[github.com]
I guess I have a bit of reading to do!